Pioneer DEH-X9500BT - Manual (Page 17)

Using voice recognition
This feature can be used on an iPod equipped
with voice recognition that is connected by
Bluetooth with the source set to
iPod or
BT Audio.
% Press and hold M.C. to switch to voice
recognition mode.
Notes
! For details on voice recognition features,
check the manual for the iPod you are using.
! Some commands may not be available on this
unit.
Connection menu operation
Important
! Be sure to park your vehicle in a safe place
and apply the parking brake when performing
this operation.
! Connected devices may not work properly if
more than one Bluetooth device is connected
at a time (e.g. a phone and a separate audio
player are connected simultaneously).
1 Press and hold to display the con-
nection menu.
# You cannot perform this step during a call.
2 Turn M.C. to select the function.
Once selected, the following functions can be
adjusted.
Device list (connecting or disconnecting a device
from the device list)
! When no device is selected in the device list, this
function is not available.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the name of a device you want
to connect/disconnect.
! Press and hold M.C. to swap between the
Bluetooth device address and the device
name.
3 Press M.C. to connect/disconnect the selected de-
vice.
Once the connection is established,
Connected
is displayed.
Delete device (deleting a device from the device list)
! When no device is selected in the device list, this
function is not available.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the name of a device you want
to delete.
! Press and hold M.C. to swap between the
Bluetooth device address and the device
name.
3 Press M.C. to display Delete YES.
4 Press M.C. to delete the device information from
the device list.
! While this function is in use, do not turn off the
engine.
Add device (connecting a new device)
1 Press M.C. to start searching.
! To cancel, press M.C. while searching.
! If this unit fails to find any available cellular
phones, Not found is displayed.
2 Turn M.C. to select a device from the device list.
! Press and hold M.C. to swap between the
Bluetooth device address and the device
name.
3 Press M.C. to connect the selected device.
! To complete the connection, check the device
name ( Pioneer BT Unit). Enter the PIN code
on your device if necessary.
! PIN code is set to 0000 as the default. You
can change this code.
! 6-digit number appears on the display of this
unit. Once the connection is established, this
number disappears.
! If you are unable to complete the connection
using this unit, use the device to connect to
the unit.
! If three devices are already paired, Device Full
is displayed and it is not possible to perform
this operation. In this case, delete a paired de-
vice first.
Auto connect (connecting to a Bluetooth device
automatically)
1 Press M.C. to turn automatic connection on or
off.
Visibility (setting the visibility of this unit)
Bluetooth visibility can be turned on so that other de-
vices can discover the unit.
1 Press M.C. to turn the visibility of this unit on or
off.
En
17
Section
02
Using
this
unit
Using this unit