What’s in the box, Before using the remote control, Replace the battery – Pioneer XW-NAS5-S User Manual
Page 5: Before you start, Before you start 01, Chapter 1
Before you start
01
5
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 1:
Before you start
What’s in the box
Please confirm that the following accessories
are in the box when you open it.
• Remote control
• Remote control holder
• Lithium battery (CR2025)
• FM wire antenna
• Power cord
• Warranty card
• Operating instructions (This document)
Before using the remote control
The remote control is shipped already set in the
remote control holder.
The battery supplied with this unit is stored in
the battery casing.
•
Remove the protective seal from the
battery casing.
When you notice a decrease in the operating
range, replace the battery (see below).
Replace the battery
When replacing the battery, use a
commercially available Lithium CR2025
battery.
1
Push the release tab to the left to open
the battery casing.
2
Pull out the battery casing.
3
Remove the battery from the casing.
4
Place a new battery in the casing.
Make sure the
side of the battery is facing
up when you place it in the space provided.
Caution
When using lithium batteries, please observe
the following:
• There is danger of explosion if the battery is
incorrectly replaced. Make sure to replace
only with the same or equivalent type
recommended by the manufacturer.
• Dispose of used battery cells immediately
after replacement. Keep away from
children.
• If swallowed, please contact a doctor
immediately.
• Lithium batteries may present a fire or
chemical burn hazard if misused. Do not
disassemble, heat above 100 °C, or
incinerate.
1
1
3
2
XW-NAS5_SYXJ.book 5 ページ 2009年8月7日 金曜日 午前10時14分