Pioneer XW-NAS5-S - Manual (Page 21)

Using the timer 08
21
En
English
Français
Deutsch
Nederlands
Italiano
Español
1 With input set to iPod or tuner, press
SETUP.
2 Use / to select ‘ ’, then press
ENTER.
Timer setting time is displayed.
3 Set the desired time for the timer.
Use / to set the hour, then press ENTER.
Set the minute in the same way, pressing
ENTER when you’re done.
4 Use / to select the input source to be
used as the timer sound, then press ENTER.
While selecting the input source, the sound
from that source will be audible (except when
beep is selected). Use the
VOLUME +/–
buttons to adjust the sound volume.
• If is selected, an electronic tone will
sound.
5 Use / to set the snooze function to
ON/OFF as desired, then press ENTER.
The timer time, input setting, snooze setting,
and volume setting will be displayed in order,
thus completing the wake-up timer setting.
• The timer indicator lights.
When the wake-up timer sounds
If the snooze function is OFF:
Press the main unit’s  STANDBY/ON button
to stop the timer playback and turn power off.
Alternately, wait for one hour (when beep is
selected, wait for one minute) and playback will
stop automatically and power will turn off.
If any other button is pressed, the timer
playback stops and normal playback of the
currently selected input source will begin.
• When finished using the timer, set the
timer function to OFF (see below).
If the snooze function is ON:
Press the main unit’s  STANDBY/ON button
to stop the timer playback and turn power off.
If any other button is pressed or playback
continues for one minute, the timer sound will
stop, but the snooze function will operate and
five minutes later the timer sound will playback
again.
• While the snooze function is operating, no
buttons can be used other than WAKE UP
and the main unit’s  STANDBY/ON. (To
turn the timer function OFF, press the
WAKE UP button two times.)
• The snooze function repeats up to five
times. After that, the unit’s power turns off
automatically.
• When finished using the timer, set the
timer function to OFF (see below).
Turning the wake-up timer on/off
• Press WAKE UP.
Each time the button is pressed, the timer
function switches alternately to ON/OFF.
• When the timer is set to ON, the timer
indicator lights.
Using the sleep timer
The sleep timer switches off the unit after a
specified time so you can fall asleep without
worrying about it.
• Press SLEEP repeatedly to select a switch-
off time.
Choose between 5 min, 15 min, 30 min, 60 min,
90 min or Off.
• The remaining time is displayed while the
sleep timer operates. 1
Note
1 The sleep timer can be reset by pressing the SLEEP button while the sleep timer is operating.
XW-NAS5_SYXJ.book 21 ページ ２００９年８月７日 金曜日 午前１０時１４分