Pioneer XW-NAS5-S - Manual (Page 23)

Additional information 09
23
En
English
Français
Deutsch
Nederlands
Italiano
Español
Resetting the system
Use this procedure to reset all system settings
to the factory default.
• When performing reset, first disconnect all
components connected to this unit.
1 Switch the unit on.
2 Press and hold VOLUME – on the top
panel, and then press and hold  STANDBY/
ON for three seconds.
Power is set to standby mode.
The next time you switch on, all the system
settings
should be reset.
About iPod
“Made for iPod” means that an electronic
accessory has been designed to connect
specifically to iPod and has been certified by
the developer to meet Apple performance
standards.
Apple is not responsible for the operation of
this device or its compliance with safety and
regulatory standards.
iPod is a trademark of Apple Inc., registered in
the U.S. and other countries.
The Bluetooth wireless
technology device cannot be
connected or operated. Sound
from the Bluetooth wireless
technology device is not
emitted or the sound is
interrupted. • Check that no object that emits electromagnetic waves in the 2.4
GHz band (microwave oven, wireless LAN device or Bluetooth
wireless technology apparatus) is near the unit. If such an object is
near the unit, set the unit far from it. Or, stop using the object
emitting the electromagnetic waves.
• Check that the Bluetooth wireless technology device is not too far
from the unit and that obstructions are not set between the Bluetooth
wireless technology device and the unit. Set the Bluetooth wireless
technology device and the unit so that the distance between them is
less than about 10 m and no obstructions exist between them.
• Check that the Bluetooth ADAPTER and the
ADAPTER PORT of the
unit are correctly connected.
• The Bluetooth wireless technology device may not be set to the
communication mode supporting the Bluetooth wireless technology.
Check the setting of the Bluetooth wireless technology device.
• Check that pairing is correct. The pairing setting was deleted from
this unit or the Bluetooth wireless technology device. Reset the
pairing.
• Check that the profile is correct. Use a Bluetooth wireless
technology device that supports A2DP profile and AVRCP profile.
Problem Remedy
XW-NAS5_SYXJ.book 23 ページ ２００９年８月７日 金曜日 午前１０時１４分