Pioneer AVH-3300BT - Manual (Page 7)

In case of trouble
Should this product fail to operate properly,
please contact your dealer or nearest author-
ized Pioneer Service Station.
Resetting the microprocessor
By pressing RESET, you can reset the micro-
processor to its initial settings without chan-
ging the bookmark information.
The microprocessor must be reset in the fol-
lowing situations:
! Before using this unit for the first time after
installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1 Turn the ignition switch OFF.
2 Press RESET with a pen tip or other
pointed instrument.
(AVH-P4300DVD)
RESET button
(AVH-3300BT)
RESET button
Note
Switch your engine ON or set the ignition switch
to ACC ON before pressing
RESET in the follow-
ing situations:
! After completing connections
! When erasing all stored settings
! When resetting the unit to its initial (factory)
settings
Demo mode
The feature demo automatically starts when
you select
Source Off for the source and con-
tinues while the ignition switch is set to ACC
or ON. To cancel the feature demo, press and
hold
MUTE. Press and hold MUTE again to re-
start. Operating the feature demo while the
car engine is turned off it may drain the bat-
tery power.
Important
Failure to connect the red lead (ACC) of this unit
to a terminal coupled with ignition switch on/off
operations may lead to battery drain.
Adjusting the response
positions of the touch panels
(Touch Panel Calibration)
If you feel that the touch panel keys on the
screen deviate from the actual positions that
respond to your touch, adjust the response po-
sitions of the touch panel. Refer to Adjusting
the response positions of the touch panels
(Touch Panel Calibration) on page 72.
En
7
Section
02
Before
you
start
Before you start