Pioneer AVH-3300BT - Manual (Page 65)

2 Display the system menu.
Refer to Introduction of menu operations on
page 44.
3 Touch Bluetooth Version Information to
display to the version of the Bluetooth
module of this unit.
Setting the rear view camera
(back up camera)
CAUTION
Pioneer recommends the use of a camera
which outputs mirror-reversed images.
Otherwise, the screen image will appear re-
versed.
This unit features a function that automatically
switches to the rear view camera video (
R.C
IN) when a rear view camera is installed on
your car and the gear shift is moved to the RE-
VERSE (R) position. (For more details, con-
sult your dealer.)
! After you set up the rear view camera set-
ting, move the gear shift to REVERSE (R)
and confirm that the rear view camera
video is shown on the display.
! Change this setting if the display switches
to the rear view camera video by error while
you are driving forward.
! To stop watching the rear view camera
video and return to the source display,
press and hold
MUTE.
! Touch the RearView source icon to display
the rear view camera image while driving.
Touch the source icon again to turn the
rear view camera off. For details, refer to Se-
lecting a source using the touch panel keys
on page 9.
1 Display the system menu.
Refer to Introduction of menu operations on
page 44.
2 Touch Camera Polarity on the system
menu to select the appropriate setting.
! Battery – When the polarity of the con-
nected lead is positive while the gear shift
is in REVERSE (R) position
! Ground – When the polarity of the con-
nected lead is negative while the gear shift
is in REVERSE (R) position
! Off – When a rear view camera is not con-
nected to this unit
Selecting the video format
You can switch the video output format of V
OUT between NTSC and PAL.
1 Display the system menu.
Refer to Introduction of menu operations on
page 44.
2 Touch Video Output Format on the sys-
tem menu to select the video output for-
mat.
NTSC
—PAL
Note
You can switch the video output format only for
the source from this unit.
Setting the video signal
When you connect this unit to an AV equip-
ment to this unit, select the suitable video sig-
nal setting.
! As this function is initially set to Auto, the
unit will automatically adjust the video sig-
nal setting.
However, the screen may turn black or
images may not be displayed properly
when
Auto has been selected and the re-
ception is weak. Normally, select the appro-
priate TV signal.
! About your country TV signal, consult with
your nearest Pioneer dealer.
! You can operate this function only for the
video signal input into the AV input.
En
65
Section
13
Menu
operations
Menu operations