Pioneer AVH-3300BT - Manual (Page 66)

1 Display the system menu.
Refer to Introduction of menu operations on
page 44.
2 Touch Video Signal Setting on the func-
tion menu.
Video Signal Setting items are displayed.
! AV – Adjusts the AV video signal
! AUX – Adjusts the AUX video signal
! Camera – Adjusts the rear view camera
video signal
! TV – Adjusts the TV video signal
(AVH-P4300DVD only)
3 Touch c or d to select the desired
video signal appears.
Auto
—PAL—NTSC—PAL-M—PAL-N—
SECAM
Selecting the area group
(Function of AVH-P4300DVD)
1 Select the TV source.
Refer to Basic operations on page 9.
2 Display the system menu.
Refer to Introduction of menu operations on
page 44.
3 Touch TV Country Group on the func-
tion menu.
4 Touch c or d until the desired area
group appears.
Country1 (CCIR channel)
—Country2 (Italy
channel)
—Country3 (U.K. channel)—
Country4 (OIRT channel)
Auto EQ (auto-equalizing)
The auto-equalizer automatically measures
the car
’s interior acoustic characteristics, and
then creates an auto-equalizer curve based on
that information.
WARNING
As a loud tone (noise) may be emitted from the
speakers when measuring the car's interior
acoustic characteristics, never perform auto TA
or auto EQ while driving.
CAUTION
! Thoroughly check the conditions before per-
forming auto EQ as the speakers may be da-
maged if these functions are performed when:
— The speakers are incorrectly connected.
(For example, when a rear speaker is con-
nected as a subwoofer output.)
— A speaker is connected to a power amp de-
livering output higher than the speaker
’s
maximum input power capability.
! If the microphone is placed in an unsuitable
position the measurement tone may become
loud and measurement may take a long time,
resulting in battery drainage. Be sure to place
the microphone in the specified location.
Before operating the auto EQ function
! Carry out auto EQ in as quiet a place as
possible, with the car engine and air condi-
tioning switched off. Also cut power to car
phones or portable telephones in the car, or
remove them from the car before carrying
out auto EQ. Sounds other than the mea-
surement tone (surrounding sounds, en-
gine sound, telephones ringing etc.) may
prevent correct measurement of the car in-
terior acoustic characteristics.
! Be sure to carry out auto EQ using the op-
tional microphone. Using another micro-
phone may prevent measurement, or result
in incorrect measurement of the car inter-
ior acoustic characteristics.
! In order to perform auto EQ, the front
speaker must be connected.
! When this unit is connected to a power
amp with input level control, auto EQ may
not be possible if the power amp
’s input
level is set below the standard level.
En
66
Section
13 Menu operations