Pioneer VSX-921 - Manual (Page 6)

6
Applications Operations
This section explains operations from calling out the measurement stored on the computer to displaying
graphs and storing data. Launch MCACC Application before performing the operations below.
Opening measurement data
1
Select “Open” under “File” on the menu bar.
2
Select the “.mcacc” file stored on the computer, then select “Open”.
The measurement data is displayed.
The “.mcacc” file is stored in the folder specified at “MCACC Data” under the AVNavigator's “Settings”
menu.
• The data used to display the reverberation characteristics graph (Reverb), the group delay characteristics
graph (Group Delay) and the MCACC parameters are not deleted even when the receiver’s power is
turned off. However, for the data used to display the reverberation characteristics graph (Reverb) and the
group delay characteristics graph the data stored in the receiver is overwritten when the reverberations
are measured again. If you wish to display graphs of various sets of data, perform the operation in
AVNavigator to transfer the measurement data to the computer each time measurements are made. For
details, see
Transferring measurement data from the receiver to the computer (page 4) .
Note
Continue