Pioneer VSX-921 - Manual (Page 5)

5
Transferring measurement data from the receiver to the computer (Continued)
• Do not quit AVNavigator or turn off the receiver’s power until data transmission is completed.
• Transmission of measurement data from the receiver to the computer is performed each time MCACC
Application is launched with the receiver’s power turned on. The measurement data is overwritten
unless the “MCACC Data Storage Folder” is changed, so if you do not wish to overwrite the
measurement data, change the storage folder at "MCACC Data" under “Settings” before launching
MCACC Application.
• The graphs for both before calibration (“Before”) and after calibration (“After”) can be displayed on the
screen displaying the reverberation characteristics graphs after Full Auto MCACC measurements
(“Reverb”), but note that the graph displayed for the characteristics after calibration is a prediction of
the reverberation characteristics after Full Auto MCACC with the EQ Type : SYMMETRY.
For details, see
About the display of the reverb characteristics graphs before and after calibration
(page 19) .
If you want to check the graph of the actually measured reverberation characteristics after MCACC
calibration (not the prediction), measure the reverb characteristics again after calibration.
For details, see
Displaying the reverb characteristics after EQ calibration (actually measured values)
(page 20) .
• If calibration is performed with the Full Auto MCACC’s EQ Type set to anything other than SYMMETRY
(to either ALL CH ADJ or FRONT ALIGN), the reverberation characteristics after calibration cannot be
predicted, so the graph for the characteristics after calibration (“After”) cannot be displayed. In this
case, the graph for the characteristics after calibration can be displayed by measuring the
reverberation characteristics again with the same EQ Type as the type used for calibration. For details,
see
Displaying the reverb characteristics after EQ calibration (actually measured values) (page 20) .
Note