Echo canceling and noise, Reduction, Switching the ring tone 42 – Pioneer DEH-P700BT User Manual
Page 42: Selecting the illumination color for, Incoming calls, Making a call by entering phone, Number, Operating this unit, Echo canceling and noise reduction, Switching the ring tone

2
Use MULTI-CONTROL to select
AUTO ANSWER.
3
Press MULTI-CONTROL to turn auto-
matic answering on.
# To turn automatic answering function off,
press
MULTI-CONTROL again.
Echo canceling and noise reduction
1
Display the function menu.
Refer to Introduction to advanced operations
on page 40.
2
Use MULTI-CONTROL to select
ECHO CANCEL.
3
Push MULTI-CONTROL left or right to
select the desired setting.
OFF (off)
—LOW—MID—HIGH
# This function can be performed even while
talking on the phone. In this case, press
MULTI-CONTROL to switch to ECHO CANCEL.
Switching the ring tone
1
Display the function menu.
Refer to Introduction to advanced operations
on page 40.
2
Use MULTI-CONTROL to select
RING TONE in the function menu.
3
Push MULTI-CONTROL left or right to
select the desired setting.
OFF (off)
—1—2—3
Selecting the illumination color
for incoming calls
You can assign one of illumination colors to
be lighted for incoming calls. A different illu-
mination color can be assigned for each differ-
ent user phone.
1
Display the function menu.
Refer to Introduction to advanced operations
on page 40.
2
Use MULTI-CONTROL to select R-COLOR
in the function menu.
3
Push MULTI-CONTROL left or right to
select the desired illumination color.
OFF (off)
—1—2—3—4—5
Making a call by entering
phone number
Important
Be sure to park your vehicle and apply the park-
ing brake when performing this operation.
1
Display the function menu.
Refer to Introduction to advanced operations
on page 40.
2
Use MULTI-CONTROL to select
NUMBER DIAL.
# You can also press DIRECT on the remote con-
trol to enter in this menu from the standby dis-
play.
3
Push MULTI-CONTROL up or down to
select a number.
# You can also perform the same operation by
pressing
0 to 9 on the remote control.
4
Push MULTI-CONTROL left or right to
move the cursor to the previous or next po-
sition.
# Up to 24 digits can be entered.
5
When you finish entering the number,
press MULTI-CONTROL.
Call confirmation appears.
# You can also perform the same operation by
pressing thumb pad on the remote control.
6
Press MULTI-CONTROL again to make a
call.
# You can also perform the same operation by
pressing
on the remote control.
7
To end the call, press
.
# You can also perform the same operation by
pressing
on the remote control.
Operating this unit
En
42
Section
02