Pioneer PDP-506XDE - Manual (Page 40)

40
En
Enjoying DTV broadcasts 09
Reconfiguring the DTV channel settings
This section describes how to reconfigure the DTV channel
settings after setting up DTV channels using Auto Installation
(page 30). You can select “DTV Setup” only when watching DTV
channels.
Reselecting a country
1
Press HOME MENU.
2
Select “Setup” ( / then ENTER).
3
Select “DTV Setup” ( / then ENTER).
4
Select “Installation” ( / then ENTER).
• The password entry screen appears. Enter your 4-digit
password using buttons 0 – 9.
5
Select “Country” ( / ).
6
Select a country ( / ).
NOTE
• The password entry screen does not appear if you have
disabled the password function. For details, see “Using a
password (AV mode only)” on page 58.
• You can select “DTV Setup” only when watching DTV
channels.
Replacing the existing channels
The following procedure discards the current DTV channel
setups and searches for receivable channels to redo the
channel setups.
1
Press HOME MENU.
2
Select “Setup” ( / then ENTER).
3
Select “DTV Setup” ( / then ENTER).
4
Select “Installation” ( / then ENTER).
• The password entry screen appears. Enter your 4-digit
password using buttons 0 – 9.
5
Select “Replace Existing Channels” ( / then ENTER).
• The system first erases all channel information and then
starts channel search.
• To quit a channel search in progress, press HOME MENU.
NOTE
• To complete “Replace Existing Channels”, there must be
more than 1 hour at least left to the next preset recording or
preset Auto Update time.
• The password entry screen does not appear if you have
disabled the password function. For details, see “Using a
password (AV mode only)” on page 58.
• You can select “DTV Setup” only when watching DTV
channels.
Adding new channels
Use the following procedure to search and register new
channels with the current DTV channel setups saved.
1
Press HOME MENU.
2
Select “Setup” ( / then ENTER).
3
Select “DTV Setup” ( / then ENTER).
4
Select “Installation” ( / then ENTER).
• The password entry screen appears. Enter your 4-digit
password using buttons 0 – 9.
5
Select “Add New Channels” ( / then ENTER).
• Channel search automatically starts. If any new channel
is found, it is automatically registered on the Media
Receiver.
Installation
Country
Add New Channels
Aerial Power
Replace Existing Channels
Restore System Defaults
Signal Check
Off
Germany
Replace Existing Channels
Existing Channels 04
New Channels Found
Search Information
Progress
20
30%
001
002
Found Channels
003
004
************
************
******
************
Installation
Country
Add New Channels
Aerial Power
Replace Existing Channels
Restore System Defaults
Signal Check
Off
Germany
PDP506XDE.book Page 40 Friday, June 17, 2005 3:08 PM