Pioneer PDP-506XDE - Manual (Page 21)

21
En
Preparation 05
En
gl
is
h
Connecting to an antenna
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used
for a coaxial cable.
Antenna cable (commercially available)
INPUT 1
INPUT 1
CONTROL SERVICE ONLY I N O U T
ANT i /o link.A
SELECT
INPUT 2 3
INPUT 3 HDMI HDMI SYSTEM CABLE
ANT(DIGITAL) IN OUT OPTICAL DIGITAL OUT COMMON INTERFACE
INPUT 2
COMPONENT VIDEO Y AUDIO OUTPUT
INPUT 4
R-AUDIO-L SUB WOOFER PB PR
BLACK WHITE
AC IN
OUT
IN
INPUT 1
INPUT 1
CONTROL SERVICE ONLY I N O U T
ANT i /o link.A
SELECT
INPUT 2 3
INPUT 3 HDMI HDMI SYSTEM CABLE
ANT(DIGITAL) IN OUT OPTICAL DIGITAL OUT COMMON INTERFACE
INPUT 2
COMPONENT VIDEO Y AUDIO OUTPUT
INPUT 4
R-AUDIO-L SUB WOOFER PB PR
BLACK WHITE AC IN
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
• For viewing both analogue and
digital broadcasts, connect the
antenna cable to the ANT OUT
terminal (antenna through out)
and ANT (analogue input)
terminal.
• If “Aerial Power” setting is
enabled, use an indoor antenna
with signal amplifier, 5V 30mA.
• For viewing analogue broadcasts only, connect
the 75-ohm coaxial cable (commercially
available) to ANT (analogue input) terminal.
If your outdoor antenna uses a 75-ohm coaxial cable with a standard
DIN45325 plug (IEC169-2), plug it into the antenna terminal at the rear of
the Media Receiver.
PDP506XDE.book Page 21 Friday, June 17, 2005 3:08 PM