Pioneer CT-L11 - Manual (Page 14)

14
En
Additional Information 4
Note
Static electricity or other external influences may cause
malfunctioning of this unit. In this case, unplug the
power cord and then plug back in. This will usually reset
the unit for proper operation. If this does not correct the
problem, please consult your nearest Pioneer service
center.
Troubleshooting
Incorrect operation is often mistaken for trouble or malfunction. If you think that there is something wrong with this
component, check the points below. Sometimes the trouble may lie in another component. Inspect the other components
and electrical appliances being used. If the trouble cannot be rectified after checking the items below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.
Problem
Can’t record
Recordings are muddy or
distorted, or you can still hear
a previous recording under
the new one
Excessive tape hiss and over-
emphasized high frequencies
Dull, muffled sound
Recording made from the
VIDEO (AUX) input are
distorted
Recording made from the
VIDEO (AUX) input very quiet
Remedy
• Check that the tape you want to record on still has the erase-protect tabs in place, or
that they are covered with tape, etc.
• Clean the tape heads.
• Make sure that Dolby NR is in the same position as when the tape was recorded.
• Make sure that Dolby NR is in the same position as when the tape was recorded.
• Set the VIDEO (AUX) input level to ATT ON.
• Set the VIDEO (AUX) input level to ATT OFF.
Published by Pioneer Corporation.
Copyright © 2001 Pioneer Corporation.
All rights reserved.
Specifications
Tracking method .......................... 4-track, 2-channel stereo
Frequency response
Type I (Normal) tape .................. 20 Hz - 16,000 Hz
± 6 dB
Type II (High/CrO2) tape ........... 20 Hz - 16,000 Hz
± 6 dB
(when recorded at –20 dB)
Signal-to-Noise Ratio .................................................. 56 dB
(EIAJ, peak recording level, audio compensation)
Dolby B NR ON ....................... 10 dB improvement at 5 kHz
Wow and Flutter ................ 0.08 % WRMS +/
−0.14 % (DIN)
Power requirements ............................... AC 230 V, 50/60Hz
Power consumption ......................................................... 12W
External dimensions .......... 220 (W) x 65 (H) x 313 (D) mm
Weight ........................................................................... 2.7 kg
Accessories
Operating Instructions ......................................................... 1
Warranty Card ...................................................................... 1
Note
Specifications and design subject to possible modification
without notice, due to improvements.