Pioneer AVH-X2600BT - Manual (Page 83)

iPod
Format Read
Sometimes there is a delay between the start of
playback and when you start to hear any sound.
Wait until the message disappears and you
hear sound.
Error-02-6X/-9X/-DX
Communication failed.
Disconnect the cable from the iPod. Once the
iPod
’s main menu is displayed, reconnect the
iPod and reset it.
iPod failure.
Disconnect the cable from the iPod. Once the
iPod
’s main menu is displayed, reconnect the
iPod and reset it.
Error-02-67
The iPod firmware version is old.
Update the iPod version.
Stop
There are no songs.
Transfer songs to the iPod.
There are no songs in the current list.
Select a list that contains songs.
Not Found
No related songs.
Transfer songs to the iPod.
iTunes tagging
iPod full. Tags not transferred.
Memory used for tag information on the iPod is
full.
Sync the iPod with iTunes and clean up the
tagged playlist.
Memory full. Tags not stored. Connect iPod.
This unit
’s flash memory used as the temporary
storage area is full.
The tag information on this unit is transferred
to the iPod automatically when an iPod is
connected.
Tag transfer failed. Reconnect your iPod.
This unit
’s tag information cannot transfer to the
iPod.
Check the iPod and try again.
Tag store failed.
Tag information cannot be stored in this unit.
Try again.
Error-8D
Built-in FLASH ROM encountered an error.
Turn the ignition OFF or ON.
Already stored
This tag information is already stored in memory.
Tag information can only be saved once for any
given song. Tag information cannot be saved
for the same song more than once.
Bluetooth
Error-10
The power failed for the Bluetooth module of this
unit.
Turn the ignition switch OFF and then to ACC
or ON.
If the error message is still displayed after
performing the above action, please contact
your dealer or an authorized Pioneer Service
Station.
MirrorLink
The application list could not be read out.
Failed to load the application list.
! Disconnect the cable from the smartphone,
and then connect the smartphone again after
a few seconds.
! Turn the ignition switch OFF and then to ACC
or ON.
If the error message is still displayed after
performing the above action, reset the
smartphone.
If the error message is still displayed after
performing the above action, please contact
your dealer or an authorized Pioneer Service
Station.
En
83
Appendix
Additional
information
Additional information