Pioneer AVH-X2600BT - Manual (Page 77)

Resetting the microprocessor
By pressing RESET, you can reset the micro-
processor to its initial settings without chan-
ging the bookmark information.
The microprocessor must be reset in the fol-
lowing situations:
! Before using this unit for the first time after
installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1 Turn the ignition switch OFF.
2 Press RESET with a pen tip or other
pointed instrument.
Refer to What
’s what on page 9.
Note
Switch your engine ON or set the ignition switch
to ACC ON before pressing
RESET in the follow-
ing situations:
! After completing connections
! When erasing all stored settings
! When resetting the unit to its initial (factory)
settings
Operating the sound mixer
You can listen to audio from the unit and your
iPhone or smartphone simultaneously. The
main sound is from the unit. The sub sound is
from the iPhone or smartphone. You can con-
trol the volume of the sub sound on the
screen.
1 Connect your iPhone or smartphone to
the unit with the RGB input.
For more details, refer to the installation man-
ual.
2 Press +/
– (VOLUME/VOL) to display the
sound mixer control bar.
The sound mixer screen appears.
iPod
Appr ppr App pp App
1 JAN
PM
12:43
Abcdefghi
1/9
Abcdefghi
Abcdefghi
Abcdefghi
01'17'' -05'29''
S.Rtrv
All All All
x 1 2
iPod
Vol.12
Mix
ON OFF Vol.12
App Sound
1 2 3
1 Source sound – Press +/– (VOLUME/VOL)
to adjust the volume of the main sound.
The main sound volume level is displayed
on the Source sound screen.
2 Mix – Touch ON or OFF to switch the
sound mixer on or off. The sub sound is
mute when
Mix is OFF.
Set to ON when you wish to output sound
for AppRadio Mode, such as the naviga-
tion sound, from the unit.
Set to
OFF when you wish to output sound
for AppRadio Mode, such as music, as the
main sound.
3 App Sound – Touch + or – on the screen to
adjust the sub sound volume. The sub
sound volume level is displayed on the
App Sound screen.
Notes
! You cannot adjust the volume of the main
sound on the screen.
! The sound mixer control bar is displayed for
four seconds. If the screen disappears, press
+/
– (VOLUME/VOL) again. The screen reap-
pears.
En
77
Section
23
Other
functions
Other functions