Behringer DSP1024P - Manual (Page 17)

17
VIRTUALIZER PRO DSP1024P
can be routed via the VIRTUALIZER PRO‘s MIDI THRU jack to your multi-effects processor.
s MIDI THRU
The MIDI THRU jack is used to loop through incoming MIDI data, i.e. any control data received at the MIDI IN
of the VIRTUALIZER PRO can be transmitted via the MIDI THRU jack to other MIDI devices/instruments.
s MIDI OUT
The MIDI OUT jack allows for transmitting MIDI data that originate from the VIRTUALIZER PRO.
The VIRTUALIZER design editor software (free download at www.behringer.com) enables you to control the
VIRTUALIZER PRO from your personal computer.
3. APPLICATIONS
The BEHRINGER VIRTUALIZER PRO is a highly flexible device that can be used for a wide variety of
applications. Prior to a presentation of the VIRTUALIZER PRO’s many uses, please note the following remarks
on how to set signal levels correctly.
3.1 Level setting
Take care to set all levels properly on the VIRTUALIZER PRO! Low levels deteriorate the dynamics of the
music signal, which results in a poor, weak and noisy sound. On the other hand, excess levels overdriving the
converters in the VIRTUALIZER PRO should also be avoided. Digital distortion is (unlike its analog counterpart)
very unpleasant to hear as it does not occur gradually but abruptly.
Use the input level meter of the VIRTUALIZER PRO to adjust the input signal, so that the Clip LED flickers only
rarely. Make sure that it never lights up permanently!
3.2 Using the VIRTUALIZER PRO in the aux bus
By using the VIRTUALIZER PRO in an aux bus of your mixing console you can feed the channel signals of
one, several or even all console channels into the VIRTUALIZER PRO, i.e. for each channel you can use the
aux busses to separately determine the reverb levels of, for instance, various drum sounds: while lots of reverb
is applied to the snare drum, the effect intensity could be reduced in the channels assigned to the tom-toms.
To use the VIRTUALIZER PRO in the aux bus, the unit must be wired as follows: