Pioneer DEH-P90DAB - Manual (Page 7)

6
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
Installation
Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connect-
ed up properly, and the unit and the system work
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunction.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the dri-
ver’s way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
• The semiconductor laser will be damaged if it
overheats, so don’t install the unit anywhere hot
— for instance, near a heater outlet.
• To prevent the ASL unit hanging from the
main unit from scratching the main unit or
your car console, it is wrapped in bubble pack-
aging. When installing, be sure to first remove
the bubble packaging to assure the unit func-
tions correctly.
• When connecting a DAB antenna to this unit, use
only a Pioneer product such as the AN-70DAB or
AN-75DAB (sold separately). If not, it may cause
malfunction.
• If installation angle exceeds 60° from horizontal,
the unit might not give its optimum performance.
(Fig. 4)
Fig. 4
• The cords must not cover up the area shown in the
figure below. This is necessary to allow the
amplifiers to radiate freely. (Fig. 5)
Fig. 5
60
°
Do not close this area.