Pioneer DEH-3200UB - Manual (Page 3)

3
EN
G
L
IS
H
Installation
3. Install the unit as illustrated.
• Make sure that the unit is installed securely in place. An unstable installation may
cause skipping or other malfunctions.
DIN Rear-mount
1. Determine the appropriate position where the holes on the bracket and the side
of the unit match.
2. Tighten two screws on each side.
Screw
Screw (M4 x 8)
Metal strap
Firewall or metal support
Nut
Dashboard or console Mounting bracket
Tapping screw
(5 mm
x 8 mm)
Removing the unit
1. Extend top and bottom of the trim ring outwards to remove the trim ring. (When
reattaching the trim ring, point the side with the groove down.)
• Releasing the front panel allows easier access to the trim ring.
2. Insert the supplied extraction keys into both sides of the unit until they click into
place.
3. Pull the unit out of the dashboard.
Fastening the front panel
If you do not plan to detach the front panel, the front panel can be fastened with
supplied screw.
Trim ring
Screw
MAN-DEH3200UB-GB.fm Page 3 Tuesday, November 17, 2009 2:25 PM