Pioneer P1-S - Manual (Page 10)

Connecting your equipments
10
En
Connecting your equipments
Before making or changing the connections, turn off the power and disconnect the power cord from the AC outlet.
Stereo receiver
Aerial connection
Supplied FM aerial (XC-P01), DAB/FM aerial (XC-
P01DAB):
Connect the supplied FM aerial wire or DAB/FM aerial wire to
the FM socket or DAB/FM socket, and position the aerial wire
in the direction where the strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for better
reception. When an external FM aerial is used, disconnect
the supplied FM aerial wire.
Note
• Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
Speaker connection
Use speakers with an impedance of 4 ohms as lower
impedance speakers can damage the unit.
1
Loosen the knobs of the speaker output terminals.
2 Insert the speaker cable wires into each of the terminal
post holes (positive (+) cable to the red knob, and
negative (–) cable to the black knob), then tighten the
knobs.
ANTENNA
AC IN
Right speaker
FM aerial
Left speaker
XC-P01
Wall socket
(AC 220 V to 230 V, 50 Hz)
Monaural mini-plug
cord (without resistor)
XC-P01DAB:
Connect the DAB/FM
aerial to the DAB/FM
socket.
To CONTROL OUT
socket of other
Pioneer component