Brother BE-438F - Manual (Page 58)

6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
KE-430F, BE-438F 49
6-5. Using cycle programs
Sewing patterns that have been recorded in user programs can be recorded in up to 30 cycle programs (C01 to C30).
One cycle program can contain up to a maximum of 50 steps (St1 to St50).
When sewing the sewing patterns in a certain order, it can be useful to record them in a cycle program beforehand.
1 Switch to cycle program recording mode.
TEST indicator flashes
While pressing the TEST key, press the key (1).
࡮ The cycle program number (C01 to C30) will be
displayed in the PROGRAM No. display, the step
number (St1 to St50) will be displayed in the menu
display, and the program number will be displayed in
the TENSION display.
࡮ If no program has been recorded for a step, ‘---‘ will
be displayed for that step.
2 Select a cycle program number.
TEST indicator flashes
Press the or key to select the cycle program
number that you would like to use.
• ‘St 1’ will be displayed.
3 Select the program number to be recorded in step 1.
TEST indicator flashes
Press the or key (2) to display the program
number to be recorded in the TENSION display (3).
࡮ If the value is changed, the display will change to
flashing.
࡮ To cancel the recording, keep the RESET key
pressed for more than 2 seconds so that ‘---‘ is
displayed.
4 Apply the program setting.
Press the ENTER key.
࡮ The display will change from flashing to illuminated,
and this means that the setting has been applied.
࡮ If you press the / keys (4), the / keys (5) or
the TEST key without pressing the ENTER key, you
can cancel the parameter changes.
2436B 2382B
2437B
2414B
2438B 2382B 2383B
2435B