Debugging options for the provider, Figure 23 – Brocade Communications Systems 53-1001778-01 User Manual
Page 54

38
Brocade SMI Agent User’s Guide
53-1001778-01
Debugging and logging options configuration
3
4. Click Apply.
The changes take effect when you restart the server. Click Start Server to restart the server.
FIGURE 23
Configure debugging options for CIMOM
Debugging options for the provider
This section describes how you can update the debugging configuration. By default, debug logging
for the provider is enabled.
You can update debugging configuration dynamically or you can update the debug properties file. If
you update dynamically, your changes are effective immediately, but are not saved. If you update
the debug properties file, your changes are saved, but are not reflected until the server is restarted.
You can specify a file to be the debug properties file, or you can use the default file, which is in the
following location:
On Linux, Solaris, and AIX:
On Windows:
You can set the following debug options:
•
Exception
•
Operation
•
Event
•
Configuration
•
Switch Data
•
Switch XML Data
•
Threadlock
Switch Data and Switch XML Data are used internally for communication with the switch.