Brocade smi agent support – Brocade Communications Systems 53-1001778-01 User Manual
Page 15

Brocade SMI Agent User’s Guide
xv
53-1001778-01
•
Brocade 8470—On the top of the chassis
•
Brocade 12000, 24000, and 48000—Inside the chassis next to the power supply bays
•
Brocade DCX—On the bottom right on the port side of the chassis
•
Brocade DCX-4S—On the bottom right on the port side of the chassis, directly above the
cable management comb.
•
Brocade Multiprotocol Router Model AP7420—On the bottom of the chassis and on the
back of the chassis.
1. World Wide Name (WWN)
Use the licenseIdShow command to display the WWN of the chassis.
If you cannot use the licenseIdShow command because the switch is inoperable, you can get
the WWN from the same place as the serial number, except for the Brocade DCX. For the
Brocade DCX, access the numbers on the WWN cards by removing the Brocade logo plate at
the top of the nonport side of the chassis.
For the Brocade Multiprotocol Router Model AP7420: Provide the switch WWN. Use the
switchShow command to display the switch WWN.
Brocade SMI Agent support
Report any problems or issues in using the Brocade SMI Agent to the following e-mail address:
When contacting support at Brocade, provide the following:
•
Operating system version and patch level
•
Sample code exhibiting problem (if possible)
•
Switch models and operating system versions, including the proxy switch
•
Compiler version
•
Error messages received
•
XML received from the Brocade SMI Agent
•
XML sent to the Brocade SMI Agent
•
Steps followed to produce the problem
•
Server-side console output and log files
•
Thread dump, if the SMI Agent is hanging or if memory consumption goes up
You can use the SMI Agent Configuration Tool, which is described in this document, to collect the
required support information to be sent.