Olympus SP-560 UZ - Manual (Page 84)

84
EN
App
endi
x
All rights reserved. No part of these written materials or this software may be reproduced or used
in any form or by any means, electronic or mechanical, including photocopying and recording or the
use of any type of information storage and retrieval system, without the prior written permission of
Olympus. No liability is assumed with respect to the use of the information contained in these written
materials or software, or for damages resulting from the use of the information contained therein.
Olympus reserves the right to alter the features and contents of this publication or software without
obligation or advance notice.
• Radio and Television Interference
Changes or modifications not expressly approved by the manufacturer may void the user’s
authority to operate this equipment. This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Adjust or relocate the receiving antenna.
- Increase the distance between the camera and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
- Consult your dealer or an experienced radio/TV technician for help. Only the OLYMPUS
supplied USB cable should be used to connect the camera to USB enabled personal computers
(PC).
Any unauthorized changes or modifications to this equipment would void the user’s authority to
operate.
“CE” mark indicates that this product complies with the European
requirements for safety, health, environment and customer protection. “CE”
mark cameras are intended for sales in Europe.
This symbol [crossed-out wheeled bin WEEE Annex IV] indicates separate
collection of waste electrical and electronic equipment in the EU countries.
Please do not throw the equipment into the domestic refuse.
Please use the return and collection systems available in your country for the
disposal of this product.
Provisions of warranty
1. If this product proves to be defective, although it has been used properly (in accordance with the written
Handling Care and Operating instructions supplied with it), during a period of two years from the date
of purchase from an authorized Olympus distributor within the business area of Olympus Imaging
Europa GmbH as stipulated on the website: http://www.olympus.com this product will be repaired, or
at Olympus’s option replaced, free of charge. To claim under this warranty the customer must take the
product and this Warranty Certificate before the end of the two year warranty period to the dealer where
the product was purchased or any other Olympus service station within the business area of Olympus
Imaging Europa GmbH as stipulated on the website: http://www.olympus.com. During the one year
period of the World Wide Warranty the customer may turn the product in at any Olympus service
station. Please notice that not in all countries such Olympus service station exists.
2. The customer shall transport the product to the dealer or Olympus authorized service station at his own
risk and shall be responsible for any costs incurred in transporting the product.
Copyright Notice
FCC Notice
For customers in Europe