Olympus µ TOUGH-8000 - Manual (Page 48)

EN
Saving battery power between shots
[POWER SAVE]
E
SETUP  POWER SAVE
Submenu 2 Application
OFF Cancels [POWER SAVE].
ON
When the camera is not being
used for approx. 10 seconds, the
monitor automatically turns off to
save battery power.
To resume standby mode
Press any button or turn the mode dial.
Using the LED illuminator as an
auxiliary light [LED ILLUMINATOR]
E
SETUP  LED ILLUMINATOR
Submenu 2 Application
OFF Disables the LED illuminator.
ON Enables the LED illuminator.
“Using the LED illuminator” (p. 24)
Displaying the current altitude/
water depth (atmospheric/hydraulic
pressure) [MANOMETER]
E
SETUP  MANOMETER
The readings may have a margin of error
depending on meteorological conditions.
Use the readings only for your reference.
Submenu 2 Application
OFF Cancels the manometer display.
ON
Displays the current altitude/
water depth (atmospheric/
hydraulic pressure) in the
shooting standby mode screen.
(–10 m to 5,000 m)
CALIBRATE
Proceed to the setting screen.
See below.
When set to [ON], a warning message
appears in the monitor as a water depth
close to 10 m (32.8 ft) is reached.
To adjust the altitude/water depth
display
1 Use 12 to select the current altitude/
water depth, and press the o button to
set.
1200m
CALIBRATE
SET OK MENU BACK
Selecting the display units for the
manometer [m/ft]
E
SETUP  m/ft
Submenu 2 Application
m This displays in meters.
ft This displays in feet.