Olympus E-5 - Manual (Page 50)

50
EN
2
Ex
pos
u
re
Start shooting.
• In single-frame shooting, the exposure changes every time the shutter button is pressed.
• In sequential shooting, hold down the shutter button until the selected number of frames are
taken.
• Releasing the shutter button stops flash bracketing shooting. When it stops, 0 blinks in
the viewfinder and on the control panel and 0 is displayed in green on the super
control panel.
How AE bracketing compensates exposure in each shooting mode
Depending on the selected shooting mode, exposure is compensated in the following way:
P mode : Aperture value and shutter speed
A mode : Shutter speed
S mode : Aperture value
M mode : Shutter speed
To apply AE bracketing to the exposure value you have compensated:
j Compensate the exposure value, then use the AE bracketing feature. AE bracketing is applied to
the exposure value you have compensated.
The higher the ISO value, the greater the camera’s light sensitivity and the better its ability to
shoot in low light conditions. However, higher values may give pictures a grainy appearance.
[AUTO] : The sensitivity is set automatically
according to the shooting conditions. For
[ISO-AUTO SET], you can set the default
(value normally used when the optimal
exposure can be obtained) and upper limit
(upper limit of ISO that automatically
changes).
g“ISO-AUTO SET” (P. 111)
[100 - 6400] : Fixed ISO sensitivity. [ISO STEP] can be
changed to [1/3EV] or [1EV]. g“ISO STEP” (P. 111)
Setting display
• 125 and 1250 are displayed in the viewfinder as 120 and 1200, respectively.
TIPS
ISO sensitivity setting
Direct button ISO j/k
Super control panel i p: [ISO]
Viewfinder Control panel
AUTO :
100 :
6400 :
ISO button
i button
k
MENU button
j
G button
When set to [AUTO], the
default value is displayed.
– – –