Broilmaster DPSBSS-1 - Manual (Page 13)

B100539-2-0610 Page 13
c
autiOn
: d
O nOt uSe an OPen flaMe tO check fOr
leakS
. c
heckinG fOr leakS with an OPen flaMe May
lead tO a fire Or exPlOSiOn
,
reSultinG in PrOPerty
daMaGe Or PerSOnal injury
.
Checking for Gas Leaks
Check for gas leaks each time you connect your Broil-
master ® gas grill and side burner to a propane gas
cylinder, when a connected cylinder has not been used
recently, or when the grill and side burner are initially
used.
Using Matches
c
autiOn
: i
f a Burner failS tO liGht after
5
SecOndS
,
turn the Burner
Off
fOr
5
MinuteS
,
tO allOw the
GaS tO clear
,
then try aGain
.
w
arninG
: n
ever OPerate the Side Burner with the
lid clOSed
.
To check for gas leaks:
1. Using dish washing detergent and water, make a
soapy solution.
2. Turn OFF the knob on both the grill and side burner’s
control panel.
3. Turn ON the gas at the supply. A hissing sound
indicates a leak. Turn OFF the gas and repair all
leaks.
4. If no hissing occurs, apply the soapy solution to all
gas connections.
5. Look for bubbles. Bubbles indicate a leak.
6. If there are bubbles, turn OFF the gas and repair all
leaks.
7. Turn the gas ON and repeat the above procedure
until all leaks are repaired.
Operating Instructions
Operating Instructions
Using the Igniter
1.
Open the side burner lid.
2. Push and turn the burner control knob counterclock-
wise to MAX.
3. Push and hold igniter button until burner lights. (Ap-
proximately 5 seconds).
1. Open the side burner lid.
2. Light and place a long wooden match next to the
burner ports under the cooking grid.
3. Push and turn the burner control knob counterclock-
wise to MAX.
Low Flame Adjustment
The low flame setting is set at the factory. To adjust
the flame height at the lowest setting:
A. Light the side burner
B. Turn the valve knob to MIN.
C. Remove the knob and locate the screw in the center
of the valve stem.
D. Use a small screwdriver to adjust the flame:
Clockw ise - Lower Flame
Counterclockwise - Higher Flame
Do not unseat the adjustment screw. If the screw is
unseated a gas leak will occur at the valve stem.
n
ote
: i
F the Flame is adjusted too low
,
a strong
wind Could blow it out
. t
he Flame maximum height
(
a
)
should be approximately
1/2
inCh at the minimum
setting
. F
igure
17.
f
iGure
17
Care and Cleaning
c
autiOn
: t
O Prevent injury dO nOt clean Side Burner
while hOt
.
For baked on residue use a brass (NOT STEEL) brush
on the cooking grid.
Clean the exterior regularly with a solution of mild de-
tergent and hot water.
Stainless steel surfaces can be easily cleaned with a
stainless steel cleaner found at your
1/2
b
urner
O
PERATION AND
M
AINTENANCE