Using commercially available external flashes, Compatible external flashes – Olympus SP-570 UZ User Manual

Page 83

Appe

ndi
x

You can use any commercial external flash that can be connected to the hot shoe. You cannot use
the camera to adjust the amount of light emitted from a commercially available external flash other
than the Olympus FL series.

g “Compatible external flashes” (P.83)

Attach the external flash to the hot shoe and connect it to the
camera.

• For instructions on how to attach the external flash, refer to the manual provided with the

flash.

Set the shutter speed and aperture value

g “M Changing the aperture value and shutter speed for shooting pictures” (P.17)
• A slow shutter speed may produce blurred images. To use the flash to best effect, you are

recommended to set the shutter speed to between 1/200 and 1/300 sec.

Turn the external flash on.

• Be sure to attach the flash to the camera before turning the flash on.

Set the flash intensity control on the external flash to AUTO and set
the ISO sensitivity and aperture value of the external flash to match
the camera ISO sensitivity and aperture value.

• For instructions on how to select the flash control mode of the external flash, refer to the

manual provided with the flash.

Note

• The flash mode set on the camera is not applied to a commercial external flash.The flash will

fire even when the flash mode is set to [

$] (flash off) on the camera.

• Check whether your external flash is synchronized with the camera before using it.

Be sure to check the following items before using a commercial external flash.
(1)

Exposures when using an external flash require that adjustments are made on the external
flash. If an external flash is used in auto mode, use a flash that can be adjusted to match the
f-number and ISO sensitivity settings on the camera.

(2)

Even if the auto f-number and ISO sensitivity settings on the external flash correspond with
those on the camera, the correct exposure may not be obtained depending on the shooting
conditions. In such a case, adjust the auto f-number or ISO value on the external flash or
calculate the distance in manual mode.

(3)

Use an external flash with an illumination angle that covers the angle of view of the lens.
However, when shooting at short range in wide mode, the bottom of the screen may be cut
off. It is advisable to use an external flash equipped with a wide adapter that provides broad
light distribution.

(4)

Use an external flash with a flash time at full emission of 1/200 seconds or less. If the flash
time is longer, not all the light may contribute to exposure.

(5)

Use of an external flash unit with communication capability or its accessory, other than
the Olympus FL series, may not only impair normal functioning, but may also cause
malfunction.

Using commercially available external flashes

Compatible external flashes