Olympus E-420 - Manual (Page 16)

16
EN
Shooting
250 F5.6
2008. 08.16
AF
arge
Normal
OFF
AUTO
Shutter button
Card access
lamp
• The shutter sounds and the picture is taken.
• The card access lamp blinks and the camera starts recording the picture.
AF confirmation
mark
Aperture value
Shutter speed
1
Place the AF target on the
subject while viewing
through the viewfinder
2
Adjust the focus
3
Release the shutter
Press the shutter
button halfway.
Viewfinder
Press the shutter button all
the way (fully).
Never remove the battery or card while the card access lamp is blinking. Doing so could
destroy stored pictures and prevent storage of pictures you have just taken.
• The focus is locked when a beep tone is output. The AF confirmation mark and the AF
target in focus light up in the viewfinder.
• The shutter speed and aperture value that have been set automatically by the camera are
displayed.
• The super control panel is not displayed while the shutter button is pressed.
Viewfinder
AF target
Super control panel
s0016_e_00_0_unified.book Page 16 Monday, February 18, 2008 2:43 PM