Beko 40WLU530HID - Manual (Page 9)

7
Note1:Your TV does not have a seperate
on/off switch, therefore to switch the power
completely off (i.e. not on standby), switch
off or unplug the TV at the mains
socket.
Note2: Your TV is equipped to
operate with TV buttons in case
your R/C is broken or the batteries
are exhausted.
3. Press the power on/off button
located on the LCD TV.
4. To power on your television,
press any numerical key or PR+
or PR- keys on the remote control. For
this process, you can also use the buttons
on your TV. The picture will appear on the
screen after a short while.
Note: If you are not going to use your
television for a long time, unplug its mains
lead from the socket.
Initial power on and performing
settings
To set up your television, read the sections
on the TV controls and making the channel
settings.
4.3-Batteries
Open the lid of the battery compartment
and make sure that you have placed the
batteries in the correct direction. For this
remote control, UM-4, IEC R03 or AAA 1.5 V
batteries are suitable.
Do not throw your old batteries into the fire,
discard them in a dedicated waste area for
this purpose.
Do not mix used batteries with new ones or
different types of batteries together.
The performance of the remote control will
be reduced at a distance of 8 meters from or
at an angle of 30 degrees beyond the centre
of the TV.
4 Start
Remove your television carefully from its
box. You can keep the packaging of your
television to use in future.
Items supplied with your television:
Instruction Manual
Mains lead
Remote control
2 Batteries
Note: Scart, HDMI, VGA and PHONO
cables are not supplied with the device.
4.1-Aerial connection
If you use a 75 Ohm coaxial cable (round
cable) as an aerial cable, connect the aerial
plug directly to the aerial input located on the
TV.
Motorized vehicles, energy lines and
telecommunication lines affect your aerial.
Therefore, be careful to install your aerial
away from these and metal surface in such
a way that it shall not move. Do not make
your aerial cable longer than required and do
not coil it. Make sure that it is not crimped
passing through a window or door. Your
aerial and cable might be affected by natural
phenomena such as rain, wind, smoke and
humidity over time. Periodically check your
aerial and equipment.
4.2-Powering on your TV and
the initial use
1. Insert the mains lead into the power supply
input located on the back panel of the LCD
TV.
2. Insert the mains lead plug supplied with the
TV into the mains socket.
or