Olympus C-3000 Zoom - Manual (Page 54)

129
When the buffer memory is
full, the upper block will light
and no other operation can be
performed until the upper
block goes off.
• When CHECK is selected in
REC VIEW in MODE SETUP,
the Save confirmation screen
will let you choose whether or
not to store the movie in the
card. (p. 208)
4
Note:
• If the recoded movie is a long one, no image may appear for a while on
the LCD monitor during the REC VIEW function. This is not a malfunction.
• During movie recording, focus is fixed at the point where focus is locked.
If your subjects are at different distances, stop recording and focus on the
objects again.
• Only Digital zoom is available during movie recording. Because the image
in the viewfinder is not affected by Digital zoom, use the LCD monitor to
check results.
• The image quality is lower compared with a still photo.
• Do not push the LCD monitor forcibly.
• Pictures that appear on the LCD monitor are for composition purposes
only.
• When the subject is viewed diagonally in the camera, the edges may
appear zigzagged on the LCD monitor. This is not a malfunction; it will be
less noticeable in Display mode.
• A strip of light may appear on the top/bottom of the LCD monitor, but this
is not a malfunction.
• When a picture is taken in a lighted area, such as in sunlight, vertical lines
may appear on the LCD monitor. This is not a malfunction.
• Printed images will be slightly cropped compared with what you see on
the LCD monitor.
F2.8 1/800 +2.0