Olympus WS-802 - Manual (Page 17)

17
1
EN
Po
we
r s
u
p
p
ly
Power supply
Connecting the USB-type AC
adapter (optional) to charge
You can charge the recorder by connecting
it to the USB-type AC adapter (A514)
(optional).
For WS-803, WS-802:
2 Plug the AC adapter into the AC
outlet.
To the AC
outlet
To the USB-type AC
adapter’s (A514)
USB connector
• Before connecting the AC adapter,
switch the USB connection setting to
[ AC Adapter ] (
☞ P.73).
• Before connecting via USB, exit HOLD
mode (
☞ P.20).
1 Plug the recorder into the AC
adapter’s USB port.
3 Press the
` OK button to start
charging.
• While [ Press OK to start charging ] is
flashing, press the
` OK button.
4 Charging is completed when
[ Battery full ] is displayed.
The charging time depends on the
amount of remaining power and the
state of the battery.
Notes
• The recorder cannot be charged if the PC
is not turned on, or if the PC is in standby,
hibernate, or sleep mode.
• Do not charge the recorder with the USB
hub connected.
• Insert the supplied rechargeable battery
and set [ Battery ] to [ Ni-MH ]. If [ Battery ]
is set to [ Alkaline ], you cannot recharge
(
☞ P.15, P.65).
• You cannot charge the battery if [ ] *1
or [ ] *2 is blinking. Charge the battery
at a temperature in the range of 5°C to
35°C (41°F to 95°F).
*1 [
]: The surrounding temperature is
too low.
*2 [ ]: The surrounding temperature is
too high.
• When the recorder’s operating time
becomes notably shorter even after
the battery is fully charged, replace the
battery with a new one.