Bosch WFMC2201UC - Manual (Page 21)

21
Troubleshooting of Minor Faults
d
WARNING
d
TO AVOID RISK OF ELECTRIC
SHOCK!
Repairs should only be carried out
by an authorized technician.
If repairs are necessary, and you
cannot eliminate the fault yourself with
the aid of the following table:
q Turn the program selector to Off.
q Disconnect the washing machine
from the power outlet.
q Turn off the water taps.
q Call Customer Service
(refer to Page 23).
Fault Possible cause Action
The door cannot be
d
No final spin" selected. Select Drain or Spin.
opened. Power failure. An interrupted program will be resumed when power is
restored. If the laundry is to be removed during a power
failure, call Customer Service
(refer to Page 23).
Program is running and/or the door is locked for safety
reasons.
Wait until the program ends; see Page 18.
Plug is loose or not inserted. Eliminate the cause.
Program selector turned to Off before end of program. Select a program.
Door cannot be opened,
even though the appliance
has been switched off and
on again.
For safety reasons the door has been locked because the
water level, temperature or speed is too high.
See "Add a garment/Interrupting the program", Page 18.
Control lights do not light A fuse has blown. Replace the fuse of the individual circuit. g g
up. Call Customer Service if this fault recurs.
Power failure. An interrupted program will be resumed when power is
restored. If the laundry is to be removed during a power
failure, call Customer Service
(refer to Page 23).
Program does not start.
Start/Pause indicator light
flashes.
Start/Pause button not pressed. Press the Start/Pause button.
Program does not start.
Indicator light end" is lit
Door not closed properly. Check whether laundry is trapped in door.
Indicator light end" is lit
and display is flashing
E:01"
Close the door (a click should be heard).
Program continues.
Spin speed cannot be
selected.
Spinning is already in progress; during spin cycle the
speed cannot be changed.
Select speed before spinning.
Program selector is set to drain; spin cycle is not
possible with this program.
If required, select another program.
Water does not enter the
machine or detergent is not
h d
Water tap(s) not turned on. Turn on water tap(s) and press Start/Pause button.
Program continues.
washed away.
Indicator light spin" is lit
Supply hose kinked or pinched. Eliminate the cause.
Indicator light spin" is lit
and display is flashing
Strainers in supply hose clogged. Clean the water inlet strainers; see Page 19.
and display is flashing
E:02" or E:03". Water pressure too low. Eliminate the cause.
Water cannot be seen in
drum.
This is not a fault.
The water level is below the visible part of the drum.
Indicator light rinse" is lit
and display is flashing
E:04" with no water reĆ
maining in tub.
Suds or pump is blocked. Use less detergent for future wash loads. Detergents
specifically designed for you High Efficientcy washer
produce fewer suds and will include the letters HE"
on the packaging. Clean the water drainage pipe
and/or drain hose. Turn the program selector to off"
and restart Drain program.
Water is flowing out from T he thread of the supply hose is not tight. Tighten the thread. g
underneath the machine. Leak in the drain hose. Replace the drain hose.