Bosch WFMC2201UC - Manual (Page 17)

17
This process is built into your machine
and occurs automatically.
This control reduces water and energy
consumption when washing small
loads.
Unbalanced load detection system
The automatic unbalanced load
detection system spins the laundry
several times to ensure even
distribution.
If the wash load is unevenly distributed,
it will not spin (for safety reasons) or the
final spin speed is reduced.
Displayed Time
Due to these and other characteristics
of the controls the actual cycle time will
vary.
When a program has been selected,
the expected program duration is
displayed.
The following will effect the displayed
time:
- Load size
- Repeated spin attempts to evenly
distributed load
- Additional rinse cycles if excessive
foam occurs
- Water pressure is too low
- Selection of additional options,
e.g. Rinse plus"
i You may notice these effects
(more or less time) changes the
displayed time when they occur in
the cycle. If no options are
selected and these effects do not
occur, the time indicated will count
down until the end of the cycle.
Washing
q Turn on the water taps.
q Turn the program selector to the
desired program.
q Load the washing machine and
close the door.
The Start/Pause indicator light
flashes (red).
q If necessary, press the button(s) for
additional option(s).
The indicator light of the selected
button is lit (red).
i If an incorrect combination was
inadvertently selected, the
indicator light of the selected
button is turned off.
q If necessary, change the spin
speed with the Spin selection
button until the the desired spin
speed indicator light is lit.
q If necessary, change the Start
time. Press the Delay Start button
until the desired Start time is
displayed.
q Press the Start/Pause button.
The indicator light is lit (red).
Display shows the run time of the
selected program. The program
starts.
i Each program step is indicated by
the indicator lights under the
display.