Bosch WFMC2201UC - Manual (Page 18)

18
During Washing
i Due to the highly engineered
suspension of this appliance, it
may experience a shudder or
shake when progressing from
lower to higher spin speeds.
This behavior is normal due to
shifting of the drum system and
should not cause concern.
Changing a program
q Turn the program selector to Off.
q Turn the program selector to a
newly selected program.
The Start/Pause indicator light
flashes.
q If required, change the settings;
see from Page 16.
q Press the Start/Pause button.
The program starts.
The indicator light is lit.
Add a garment /
Interrupting the program
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the program at
any time.
i It is not recommended to add
laundry after the washing phase is
complete.
i You can add or reduce laundry as
long as the Start/Pause indicator
light flashes (red).
q Press the Start/Pause button.
The Start/Pause indicator light
flashes.
q Open the door.
q Place/remove the laundry.
q Close the door.
q Press the Start/Pause button.
The program continues.
The indicator light is lit (red).
i When the Start/Pause indicator
light is lit (red), the program can be
interrupted, however the door
cannot be opened for safety
reasons (water level, temperature
or speed too high).
i If the spin speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
Pause" mode when the drum is at
a standstill.
Canceling an active
program
If you would like to terminate a program
and remove the laundry:
i If a program is interrupted at a high
temperature, leave the laundry to
cool down until the glass is cool to
touch.
q Turn the program selector to Off.
q Turn the program selector to Drain
or Spin.
i For Spin, select the desired spin
speed (but not no final spin).
q Press the Start/Pause button.
q Wait until this program ends.
q Open the door.
q Unload the laundry.
i If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
i If the program is terminated by
switching off the appliance, the
door may remain locked.
After Washing
The Start/Pause indicator light goes
out.
0:00
appears in the display.
q Open the door.
q Turn the program selector to Off.
q Close the taps.
q Remove the laundry.
If No final spin" preselected
The Start/Pause indicator light flashes.
q Turn the program selector to
Drain. The Start/Pause indicator
light flashes.
q Press the Start/Pause button.
The indicator light is lit.
q When this program has ended,
open the door.
q Turn the program selector to Off.
q Close the taps.
q Remove the laundry.
i After washing, leave the loading
door ajar to allow the inside of
the washing machine to dry.