Bosch WFMC2201UC - Manual (Page 16)

16
No final spin
The indicator light no final spin" is lit
red.
For delicate laundry, the water remains
in the machine after the last rinse.
Use this setting to avoid creasing if the
clothing cannot be taken out of the
washing machine immediately upon
completion of the cycle.
CAUTION
Before unloading you must drain the
remaining water by selecting Drain
or Spin and starting the machine.
Modifiers
Spin Selection
Preset cycle setting of max. spin speed
can be changed.
Press this button until the desired
setting lights up.
Delay Start
Before starting a program you can
modify by when the cycle should be
started.
Press Delay Start button. The display
shows the start time 0:00
.
The time can be delayed up to a
maximum of 19 hours (with 1 hour
increments) by pressing the Delay
Start button again.
The Start time begins running
immediately after pushing the
Start/Pause button. This is indicated
by the points between the digits
flashing.
i Changes to the Start time are
possible at any time, press the
Delay Start button until the new
time appears.
i If the program is changed or if the
program is interrupted, the
preselected Start time is also
interrupted. The Ready in time of
the program is displayed. The
Start time must be reselected.
Option buttons
Bleach
When this button is pressed, a bleach
cycle will be added to the selected
cycle.
The washing cycle time is extended
accordingly.
Rinse Plus
When this button is pressed, an
additional rinsing cycle will be added to
the selected cycle.
Washing cycle time is extended
accordingly.
Heavy duty
The Heavy duty option is
recommended for use ONLY for
heavily soiled clothes that require
the removal of tough, ground-in
protien-based stains. It is NOT
recommended to use the Heavy duty
option with other cycles when
laundering normal or lightly soiled
clothes.
Washing time is extended.
Only cold water is introduced to the
drum. The washing machine then
heats the water to the selected wash
temperature. By raising the
temperature from cold up to the set
temperature all components of the
detergent are activated in stages for
best stain removal and cleaning results.
Acoustic Signal
An acoustic signal indicates program
statuses (e.g. start/end of program and
operating faults.)
To activate the signal:
q Select a program.
q Press two of the Option
Buttons(e.g. Bleach and Rinse
Plus) until a long signal is emitted.
To deactivate the signal:
q Select a program.
q Press two of the Option Buttons
and hold until a short signal is
emitted.
i Do not activate/desactivate the
acoustic signal during a cycle.
Indicator light above the
Start/Pause" button
The indicator light conveys the
following information:
- Indicator light flashing red:
Program can be started.
- Adding laundry is possible.
- Indicator light is lit red. Program is
running.
- Adding laundry is not possible
because the door is locked for
safety reasons.
Laundry may be added after pressing
the Start/Pause button.
Special features
Auto Load adjust
Auto Load adjust" adjusts the water
and energy consumption for each
program and determines the amount of
laundry and type of fabrics.