Brother CS-8060 - Manual (Page 55)

Sewing 49
GETTING READ
Y
CONTENTS
SEWING BASICS
U
T
IL
IT
Y
S
T
ITCHES
APPENDIX
INDEX
Cutting the thread
When you have finished sewing, cut the threads.
1
When you wish to finish the stitching and the
sewing machine is stopped, press
(needle position button) once to raise the
needle.
1 Needle position button
X The needle is raised.
2
Raise the presser foot lever.
1 Presser foot lever
3
Pull the fabric to the left side of the machine,
and then pass the threads through the thread
cutter to cut them.
1 Thread cutter
■ Using the thread cutter button
(Only for models equipped with the thread
cutter button)
When using a model equipped with a thread
cutter button, the thread can easily be cut if the
button is pressed.
1
When you wish to finish the stitching, press
(thread cutter button) once.
1 Thread cutter button
X The threads are cut and the needle is raised.
2
Raise the presser foot lever.
1 Presser foot lever
Note
● Do not press the thread cutter button if there
is no fabric under the presser foot or while
the machine is sewing, otherwise damage to
the machine may occur.
● When sewing with thread thicker than #30,
nylon or metallic threads, or other special
threads, use the thread cutter on the side of
the machine to cut the threads.
1
1
1
● Do not press the thread cutter button
after the threads have already been cut,
otherwise the needle may break, the
threads may become tangled or damage
to the machine may occur.
1
1
CAUTION
S2_brotherE.book Page 49 Wednesday, May 14, 2003 8:05 PM