AEG A93100GNW0 - Manual (Page 28)

Problem Possible cause Solution
There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
8.2 Customer Service
If your appliance is still not working
properly after making the above checks,
contact the nearest service centre.
To obtain fast service, it is essential that
when you apply for it you specify the
model and serial number of your
appliance which can be found either on
the guarantee certificate or on the rating
plate located on the external right side
of the appliance.
8.3 Replacing the lamp
WARNING!
Do not remove the lamp cover
at the time of replacement.
Do not operate the freezer if
the lamp cover is damaged or
missing.
1. Disconnect the mains plug from the
mains socket.
2. Replace the used lamp with a new
lamp of the same power and
specifically designed for household
appliances (the maximum power is
shown on the lamp cover).
3. Connect the mains plug to the mains
socket.
4. Open the lid. Make sure that the
lamp comes on.
9. INSTALLATION
WARNING!
Refer to Safety chapters.
9.1 Positioning
CAUTION!
If you are discarding an old
appliance that has a lock or
catch on the lid, you must
ensure that it is made
unusable to prevent young
children being trapped inside.
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
www.aeg.com 28