AEG A93100GNW0 - Manual (Page 21)

3. OPERATION
3.1 Control panel
1 2 3 4
1 High temperature alarm light
2 Pilot light
3 FROSTMATIC light
4 FROSTMATIC switch and Alarm reset
3.2 Switching on
1. Insert the plug into the wall socket.
2. Turn the Temperature regulator
clockwise to a medium setting.
The pilot light will light up.
If the temperature inside the
appliance is too high the
Alarm light will blink. Active
the FROSTMATIC function.
3.3 Switching off
Turn the Temperature regulator to the
OFF position.
3.4 Temperature regulation
The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as
follows:
• to obtain the minimum coldness, turn
the Temperature regulator towards
.
• to obtain the maximum coldness, turn
the Temperature regulator towards
.
A medium setting is generally
the most suitable.
However, the exact setting
should be chosen keeping in
mind that the temperature
inside the appliance depends
on:
• room temperature
• how often the lid is opened
• the quantity of food stored
• the location of the
appliance.
3.5 High temperature alarm
An increase in the temperature in the
freezer (for example due to an power
failure) is indicated by switching on of the
Alarm light
During the alarm phase, don't place food
inside the freezer.
When normal conditions are restored the
Alarm light will switch off automatically.
3.6 FROSTMATIC function
The freezer compartment is suitable for
long term storage of commercially frozen
and deep-frozen food, and for freezing
fresh food.
Place food in the freezer after a pre-
cooling the appliance for 24 hours.
ENGLISH 21