AEG HC411520GB - Manual (Page 9)

• You do not deactivate a roasting zone
or change the temperature. After 90
minutes comes on and the hob
deactivates. Before next use, set the
roasting zone to .
4.3 The heat setting
To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct
heat setting.
The display flashes until the roasting
zone reaches the temperature. Then a
signal sounds and the display shows the
temperature.
4.4 Timer
Count Down Timer
You can use this function to set how long
the roasting zone should operate for a
single cooking session.
First set the roasting zone then set the
function. The selection of the Timer
function is possible for roasting zones
that are active and after the temperature
is set.
To set the roasting zone: touch
again and again until the indicator of a
necessary roasting zone comes on. When
this function is active, comes on.
To activate the function: touch of
the timer to set the time (00 - 99
minutes). When the indicator of the
roasting zone starts to flash slowly the
time counts down.
To see the remaining time: set the
roasting zone with
. The indicator of
the roasting zone starts to flash quickly.
The display shows the remaining time.
To change the time: set the roasting
zone with
. Touch or .
To deactivate the function: set the
roasting zone with
and touch .
The remaining time counts back to 00.
The indicator of the roasting zone goes
out.
When the time comes to an
end, the sound operates and
00 flashes. The roasting
zone deactivates.
To stop the sound: touch .
CountUp Timer (The count up
timer)
You can use this function to monitor how
long the roasting zone operates.
To set the roasting zone (if more than
1 roasting zone operates): touch
again and again until the indicator of a
necessary roasting zone comes on. When
this function is active, comes on.
To activate the function: touch . The
symbol goes out and comes on.
To see how long the roasting zone
operates: set the roasting zone with
.
The indicator of the roasting zone starts
to flash quickly. The display shows how
long the zone operates. During the first
minute the display shows the time in
seconds. After the first minute the
display shows the time in minutes.
To deactivate the function: set the
roasting zone with
and touch .
The symbol goes out and comes
on.
To reset the function: touch . The
time counts back to 00.
If two functions operate at
the same time, the display
shows the CountUp Timer
function first.
ENGLISH 9