AEG HC411520GB - Manual (Page 14)

temperature is 80°C. The function
locks the control panel, but not .
2. When the temperature reaches 80°C
an acoustic signal sounds, and the
control panel becomes unlocked.
3. Put ice cubes one by one on the
roasting zone (you can use also cold
water). At the same time, use a
spatula to remove the remaining
roasting pieces and push all pieces
into the trough.
4. Dry the hob with a clean cloth.
6.3 Cleaning when the hob is
cold
1. Apply a usual cleaning agent to the
roasting surface and let it set for 5
minutes.
2. Remove the cooking residue with a
spatula.
3. Clean the hob with a moist cloth.
4. Dry the hob with a clean cloth.
5. When the hob is dry, rub the roasting
surface with some cooking oil.
6.4 Glass bar
• Do not use the scraper or sharp
objects to clean the glass bar and the
space between it and glass ceramic.
Glass bar is attached to the ceramic
plate.
• Do not put the pots on the glass bar.
• Make sure that the pans and pots do
not touch the glass bar.
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem Possible cause Remedy
You cannot activate or oper-
ate the hob. The hob is not connected to
an electrical supply or it is
connected incorrectly. Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
The fuse is released. Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
You touched 2 or more sen-
sor fields at the same time. Touch only one sensor field.
www.aeg.com 14