AEG DE4003000M - Manual (Page 7)

Refer to chapter "Care and
Cleaning".
4.2 Setting the time
The oven only operates after
time set.
When you connect the appliance to the
electrical supply or in case of a power
cut, the Time function indicator flashes
automatically.
To set the current time use
or .
After approximately 5 seconds, the flash-
ing stops and the display shows the time
of day set.
You can only change the Time
of day
if :
• the switch-on lock is not on
• none of the clock functions
Duration or End is set
• no oven function is set.
4.3 Preheating
Preheat the empty appliance to burn off
the remaining grease.
Preheat the two ovens. Heat up one
oven at a time.
Set the functions listed below, if applica-
ble.
1.
Set the function and the maxi-
mum temperature.
2. Let the appliance operate for one
hour.
3.
Set the function and the maxi-
mum temperature.
4. Let the appliance operate for ten mi-
nutes.
5. Set the function and the maxi-
mum temperature.
6. Let the appliance operate for ten mi-
nutes.
Accessories can become hotter than
usually. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow is sufficient.
4.4 Control panel
7 6 5 4 2
1
3
Num-
ber
Button Function Description
1 – Display To show the current settings of the oven.
2 Clock function To set a clock function.
3
Increase / De-
crease
To set the value for the temperature and
time.
4 Temperature To show an oven temperature.
ENGLISH
7