AEG L99695HWD - Manual (Page 6)

• Make sure not to cause damage to the
mains plug and cable.
• Connect the mains plug to the mains
socket only at the end of the installa-
tion. Make sure that there is access to
the mains plug after the installation.
• Do not pull the mains cable to discon-
nect the appliance. Always pull the
mains plug.
• Only for UK and Ireland. The appliance
has a 13 amp mains plug. If it is neces-
sary to change the fuse in the mains
plug, use a 13 amp ASTA (BS 1362)
fuse.
• Permanent connection. To connect
the appliance permanently, install a
double-pole isolating switch between
the appliance and the electricity supply.
It must have a minimum distance of 3
mm between the switch contacts and it
must be the correct type for the neces-
sary load. It must agree with the last
electrical legislation. The switch must
not break the yellow and green ground
cable.
Only a qualified electrician must install
this type of device.
DISPOSAL
WARNING!
Risk of injury or suffocation.
• Disconnect the appliance from the
mains supply.
• Cut off the mains cable and discard it.
• Remove the door catch to prevent chil-
dren and pets to get closed in the ap-
pliance.
IN THE INTEREST OF THE ENVIRONMENT
• Connect the appliance to the FOUL sys-
tem for the drain water. The sewage
works keeps the drain water for the
treatment before to release safely it in-
to a river. Do not connect this appliance
to the surface drain system of the water
because it releases the drain water di-
rectly into a river or stream without a
treatment and this can cause of pollu-
tion. Contact your local water authority
to have more information.
6 www.aeg.com