AEG L99695HWD - Manual (Page 27)

Set drying time value
• After some seconds the display shows
the total duration of the cycles:
Final time value (wash-
ing + drying + anti-
crease + cooling pha-
ses)
If you set a drying time of only 10
minutes, the final time value in-
cludes also the anti-crease and
the cooling phases.
• Press button 6 to start the programme.
The door is locked
The display shows the new time value
each minute.
• When the programme is completed,
the appliance stops automatically.
• The acoustic signals operate.
•
When the door locked symbol
goes off, you can open the door.
• Remove the laundry from the appli-
ance. Make sure that the drum is emp-
ty.
• Close the water tap.
• Keep the door ajar, to prevent mildew
and odours.
FLUFF IN THE FABRICS
During the washing and/or drying phase,
some types of fabric, (sponge, wool,
sweatshirt) could release fluff.
The released fluff could stick to the fabrics
during the next cycle.
This inconvenient increases with technical
fabrics.
To prevent the fluff in your laundry, we
recommend that you:
• To do not wash dark fabrics after you
washed and dried light coloured fabrics
(new sponge, wool, sweatshirt ) and the
contrary.
• To dry this type of fabrics at open air
when they are washed the first time.
• To clean the drain filter.
• After the drying phase, clean the empty
drum, the gasket and the door with a
wet cloth.
To remove the fluff inside the drum, set
a special programme:
• Empty the drum.
• Clean the drum, the gasket and the
door with a wet cloth.
• Set the rinse programme.
• Press at the same time button
9 and
button 7 to activate the cleaning
function until the display shows CLE.
• Press button 6 to start the pro-
gramme.
ENGLISH
27