AEG L99695HWD - Manual (Page 43)

• On the edge of a sink.
• Make sure that the plastic guide cannot
move when the appliance drains. At-
tach the guide to the water tap or the
wall.
• To a stand pipe with vent-hole.
Refer to the illustration. Directly into a
drain pipe at a height of not less than
60 cm (23.6”) and not more than 100 cm
(39.3”). The end of the drain hose must
always be ventilated , i.e. the inner di-
ameter of the drainpipe (min. 38 mm —
min. 1.5”) must be larger than the ex-
ternal diameter of the drain hose.
• If the end of the drain hose is this (see
the drawing), you can push it directly in-
to the stand pipe.
Without the plastic hose guide.
• To a sink spigot.
Refer to the illustration. Put the drain
hose in the spigot and tighten it with a
clip. Make sure that the drain hose
makes a loop to prevent that remaining
particles go in the appliance from the
sink.
ENGLISH
43