AEG L99695HWD - Manual (Page 26)

USING THE APPLIANCE - WASHING & DRYING
NON-STOP PROGRAMME -
WASHING & AUTOMATIC
DRYING
CAUTION!
Do not put a plastic device/ball
for the detergent into the drum.
• Press button
1 to activate the appli-
ance.
• Load the laundry.
• Measure out the detergent and fabric
conditioner.
• Turn the programme dial to the wash-
ing programme. The display shows the
symbols of the different washing pha-
ses.
CAUTION!
Do not set a spin speed lower
than the automatic speed of the
set programme.
• Set the available options.
• Press the button
8 until the black line
appears under one of the dryness level
symbol.
The iron dry level
comes on
The cupboard dry lev-
el comes on.
The extra dry level
comes on.
The drying symbol
comes on.
The anti-crease sym-
bol comes on.
The time value on the display is the du-
ration of the washing + drying cycles
calculated on a default load size.
• Press button 6 to start the pro-
gramme.
The set dryness level sym-
bol stays on.
The others level symbols go
off.
The door locked symbol
comes on.
The display shows the new time value
each minute.
The last minutes of the drying cy-
cle the appliance performs the an-
ti-crease and the cooling phases.
• When the programme is completed,
the appliance stops automatically.
• The acoustic signals operate.
•
When the symbol goes off, you
can open the door.
• Remove the laundry from the appli-
ance. Make sure that the drum is emp-
ty.
• Close the water tap.
• Keep the door ajar, to prevent mildew
and odours.
NON-STOP PROGRAMME -
WASHING & TIMED DRYING
CAUTION!
Do not put a plastic device/ball
for the detergent into the drum.
• Press button 1 to activate the appli-
ance.
• Load the laundry.
• Measure out the detergent and the fab-
ric conditioner.
• Turn the programme dial to the wash-
ing programme. The display shows the
symbols of the different phases of the
washing cycle.
Do not set a spin speed lower than
the automatic speed of the set pro-
gramme.
• Set the available options.
• Press the button
5 to set the drying
time value.
The drying symbol comes
on.
The anti-crease symbol
comes on.
The drying time symbol
comes on.
• The display shows the set drying value
time.
26 www.aeg.com