Set ting the markers 4-13, Setting the markers -13 – Anritsu S251B User Manual

Page 59

Setting the Markers

The following procedure sets the markers.

Step 32. Press the

MARKER

key to call up the Markers menu.

Step 33. Press the

soft key to select the M1 marker function. Press the

EDIT

soft key

and enter 8, 2, 4 using the keypad or Up/Down arrow key. Press

ENTER

to set

M1 to 824 MHz. (Note: pressing the

ON/OFF

soft key activates or deactivates

the M1 marker function.)

Step 34. Press the

BACK

soft key to return to the Markers menu.

Step 35. Repeat steps 33 and 34 for markers M2, M3, and M4. Set M2 to 960 MHz, M3

to 1710 MHz, and M4 to 1990 MHz. Figures 4-10 and 4-11 depict the SWR and
Return Loss measurements).

NOTE:
Refer to page 4-4 for instructions on saving and recalling a setup or display.

4-13

Chapter 4 Measurements

Figure 4-10.

Cable SWR Measurement Results

Figure 4-11.

Cable Return Loss Measurement Results