AEG BY9314001M - Manual (Page 14)

2. Touch until the display shows
"00:00" and the Count Up Timer
starts to count up again.
7.3 Setting the DURATION
1. Activate the appliance and set an
oven function and temperature.
2. Touch again and again until the
display shows .
flashes in the display.
3. Use or to set the minutes for
DURATION.
4. Touch to confirm.
5. Use or to set the hours for
DURATION.
If you touch or while you set the
DURATION, the appliance switches to
the setting of the END function.
6. When the set time ends, an acoustic
signal sounds for two minutes.
and time setting flash in the display.
The appliance deactivates.
7. Touch a sensor field or open the
oven door to stop the acoustic
signal.
8. Deactivate the appliance.
7.4 Setting the END
1. Activate the appliance and set an
oven function and temperature.
2. Touch again and again until the
display shows .
flashes in the display.
3. Use or to set the END and
or to confirm. First you set the
minutes and then the hours.
When the set time ends, an acoustic
signal sounds for two minutes. symbol
and the time setting flash in the display.
The appliance deactivates.
4. Touch a sensor field or open the
oven door to stop the acoustic
signal.
5. Deactivate the appliance.
7.5 Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set an oven function (or a
programme) and temperature (refer
to "Setting the oven function" and
"Changing the temperature").
2. Set the DURATION (refer to "Setting
the DURATION").
3. Touch again and again until
flashes in the display.
4. Touch to set the SET+GO
function.
The display shows and with an
indicator. This indicator shows which
clock function is activated.
5. Touch a sensor field (apart from ON /
OFF) to start the SET+GO function.
7.6 Setting the MINUTE
MINDER
Use the MINUTE MINDER to set a
countdown (maximum 23 h 59 min). This
function has no effect on the operation
of the oven. You can set the MINUTE
MINDER at any time and also when the
appliance is off.
1. Touch .
and "00" flash in the display.
2. Use or to set the MINUTE
MINDER. First you set the seconds,
then the minutes and the hours.
3. Touch or the MINUTE MINDER
starts automatically after five
seconds.
When the set time ends, an acoustic
signal sounds for two minutes and 00:00
and flash in the display.
4. Touch a sensor field or open the
oven door to stop the acoustic
signal.
7.7 Setting the Time delay
function
The DURATION and END can be
used at the same time, if the appliance is
to be switched on and off automatically
later. In this case, first set the DURATION
www.aeg.com 14