ATEN ATEN MasterView CS-1764 - Manual (Page 22)

CS-1762 / CS-1764 User Manual
12
Powering Off and Restarting
If it becomes necessary to Power Off the Master View unit, before starting it
back up you must do the following:
1. Shut down all the computers that are attached to the switch.
2. Unplug the switch’s power adapter cable.
3. Wait 10 seconds, then plug the switch’s power adapter cable back in.
4. After the switch is up, Power On the computers.
Port ID Numbering
Each CPU port on the CS-1762 / CS-1764 switch is assigned a port number (1
or 2 for the CS-1762; 1 to 4 for the CS-1764). The port numbers are marked on
the rear panel of the switch (see page 5 for details).
The Port ID of a computer is derived from the CPU port number it is connected
to. For example, a computer connected to CPU port 2 has a Port ID of 2.
The Port ID is used to specify which computer gets the KVM USB peripheral,
and audio focus with the Hotkey port selection method (see page 15 for
details).
cs1762.book Page 12 Friday, February 17, 2006 10:21 AM