ATEN ATEN MasterView CS-1764 - Manual (Page 19)

9
Chapter 2.
Installation
Before you Begin
Cable Connection
To set up your Master View CS-1762 / CS-1764 installation, refer to the
installation diagrams on the following pages (the numbers in the diagrams
correspond to the steps, below), and do the following:
1. Plug your USB keyboard and USB mouse into the USB Console Ports
located on the unit’s front panel.
2. Plug your microphone, speakers, and monitor into the Console ports
located on the unit’s rear panel.
3. Using a KVM cable set (provided with this package), plug the DVI
connector into any available DVI socket in the CPU Port section of the
switch, then plug the accompanying USB, microphone and speaker
connectors into their corresponding USB, microphone, and speaker
sockets.
Note: Verify that all the plugs are in the same CPU Port sockets (all in Port
1, all in Port 2, etc.), and that each socket is marked with an
appropriate icon to indicate itself.
4. At the other end of the cable, plug the USB, video, microphone, and
speaker cables into their respective ports on the computer.
5. Plug your USB peripherals into the type A sockets in the USB hub section.
6. Plug the power adapter that came with your switch into an AC power
source, then plug power adapter cable into the switch’s Power Jack.
7. Turn on the power to the computers.
Make sure that power to all the devices on the installation are
properly grounded.
cs1762.book Page 9 Friday, February 17, 2006 10:21 AM