Asus M2NBP-VM CSM - Manual (Page 69)

ASUS M2NBP-VM CSM 2-25
Select Menu
Item Specific Help
Select Yes if you are using
a Plug and Play capable
operating system Select
No if you need the BIOS to
configure non-boot devices
PCIPnP
Plug & Play O/S [ No ]
Primary Display Adapter [PCI-E]
Resources Controlled By [Auto]
x IRQ Resources
** PCI Express relative itmes **
Maximum Payload Size [4096]
Phoenix-Award BIOS CMOS Setup Utility
Advanced
2.4.5 PCIPnP
Plug & Play O/S [No]
When set to [No], the BIOS configures all the devices in the system. When set to
[Yes] and if you install a Plug and Play operating system, the operating system
configures the Plug and Play devices not required for boot.
Configuration options: [No] [Yes]
Primary Display Adapter [PCI-E]
Sets which graphics controller to use as primary boot device.
Configuration options: [PCI] [Onboard] [PCI-E]
Resources Controlled By [Auto]
When set to [Auto], the BIOS automatically configures all the boot and Plug and
Play compatible devices. Set to [Manual] if you want to assign the IRQ DMA and
memory base address fields. Configuration options: [Auto] [Manual]
When the item Resources Controlled By is set to [Auto], the item IRQ Resources
is grayed out and not user-configurable. Refer to the section “IRQ Resources”
for information on how to enable this item.
IRQ Resources
This sub-menu is activated only when the Resources Controlled By item is set to
[Manual].
Select Menu
Item Specific Help
Legacy ISA for devices
compliant with the
original PC AT bus
specification, PCI/ISA
PnP for devices
compliant with the
IRQ Resources
IRQ-5 assigned to [ PCI Device ]
IRQ-7 assigned to [PCI Device]
IRQ-9 assigned to [PCI Device]
IRQ-10 assigned to [PCI Device]
IRQ-11 assigned to [PCI Device]
IRQ-14 assigned to [PCI Device]
IRQ-15 assigned to [PCI Device]
Phoenix-Award BIOS CMOS Setup Utility
Advanced